Setting up a Brick Paver Walkway or Red Clay Bricks

The usage of Bricks or Pavers to produce a walkway or patio matches a house in a method that is unrivaled. In addition, setting up a Brick or Paver sidewalk does not always require a pro.

The key to installing a Brick or Paver Walkway is to very first properly prepare the area where the bricks/pavers are to be installed. In addition, string lines need to be strung on each side of the pathway.
Once the location has been dug down, 3/4" gravel stone need to be laid in and tamped down tightly. 2" of sand, or stone dust should be spread over the gravel. Again the sand/stone dust must be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline need to equate to the density of the brick or paver.

Now that you have a stable base, put a 1" pipeline or journal board the length of the sidewalk on either side of the pathway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready location. These strips will act as your walkway border and aid to keep the stability and shape of the walkway.

The secret to laying the bricks/pavers is to ensure that they interlock with each other. Constantly stagger surrounding rows of bricks by read more 1/2 of a brick to interlock them. This will once again help preserve the integrity of the pathway.

Inevitably bricks/pavers will need to be cut or split when building the walkway. Unless you want to buy or rent an expensive wetsaw, I would recommend acquiring an easy brick/paver splitter. It is generally a sculpt with a broad end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you want to break the brick. Utilizing a hammer strike the butt end of the chisel securely. You might need to do this a couple of times. You might also desire to flip the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within one or 2 strikes the brick/paver ought to break easily. If your walkway has curves you will require to buy/rent a wetsaw.

After setting up the bricks, build up the outside edges with extra sand, and after that shovel in the topsoil and pack down firmly.
Spread stone dust over the brand-new walkway and sweep into the cracks. Repeat this procedure a number of times to ensure the cracks are completely filled. This will complete the interlocking of the bricks and assist to remove any weed development. Simply add grass seed to the outside edges and you must have a beautiful entrance to your home within a couple of weeks.


In addition, setting up a Brick or Paver sidewalk does not always require a pro. The secret to setting up a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, website put a 1" pipeline or ledger board the length of the walkway on either side of the walkway. These strips will act as your walkway border and help to maintain the stability and shape of the pathway. Inevitably bricks/pavers will need to be cut or divided when developing the pathway.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Setting up a Brick Paver Walkway or Red Clay Bricks”

Leave a Reply

Gravatar